Owner`s manual

PureLink by Dtrovision
TABLE OF CONTENTS 89
- T02: 1920 x 1200 - P02: Cross Hatch
- T03: 720 x 480P - P03: 16 Gray
- T04: 1280 x 720P - P04: 256 Gray
- T05: 1920 x 1080P - P05: 4Color Gray
Example:
Command Codes Action
*255OTALLT01P01!  Set all Output to 1024x768 and color bars test pattern
*255OTO01,O02,O03T02P04!  Set Output 1,2 and 3 to 720x480p and 256 gray test Pattern
*255OTO01-09T05P05!  Set Output1~9 to 1920x1080p and 4 color gray test Pattern
*255OTALLT00P00!  Disable test pattern to all outputs
OF: Output Channel Information Request
The "OF" is an initiation command for Output channel general information request. The
characters and numbers that follow the "OF" command tell the system, to request
Output channel information of selected Output. The last character “!” is found at the end
of a command code which tells the system to execute the command.
For example, the command code
*255OFO01! 
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255
(OF) Output channel general information request on (O01) Output 01 (!) take the
command. For a complete list of command characters and their functions, see
examples below.
Example:
Command Codes Action
*255OFO02!  Request Output 2 information
OE: Output Extender Scaler Timing Select
The "OE" is an initiation command for Output Extender Scaler timing selection. The
characters and numbers that follow the "OE" command tell the system, set scaling
timing on selected Output. The last character “!” is found at the end of a command code
which tells the system to execute the command. For a complete list of command
characters and their functions, see examples below.
 OE command only applies to the HDMI with scaling Board and CATx/Fiber Output
Board with PM-CR102 (CATx) and PM-FR102 (Fiber) Extender Receiver.