User manual

ManualsBrandsPureLink ManualsComputer equipmentPM-16X

Encore Presentation System Router Support Rev 03

- 1 -

Encore Presentation System Router support

(Code Revision 2.33.00 or higher)

 AutoPatch

 Barco MatrixPRO-II Analog, 3G SDI and DVI

 Barco MatrixPRO Analog, SDI and DVI

 Barco FSN Presentation Switcher

 BlackMagic Videohub SDI

 DVILink 18x18 DVI

 Extron

 FSR Pathfinder

 GefenPRO DVI

 Grass Valley

 ISIS

 Lantronix UDS-200/UDS-2100 Serial-to-Ethernet device

 Leitch

 LightWare

 Nevion SDI

 Nvision SDI

 Opticis DVI

 Purelink DS-1818M II DVI

 Sierra

 PureLink-2 (PM Series – 32x32 HDMI, DVI, 3G-SDI, firmware 2.20)

Summary of content (5 pages)

PAGE 1
Encore Presentation System Router Support Encore Presentation System Router support (Code Revision 2.33.
PAGE 2
Encore Presentation System Router Support Rev 03 Encore Presentation System Router support (Code Revision 2.33.00 or higher) Setup For serial connection refer to the Router User Manual for the RS232 pin out of the router. Connect the router to the EXT COMM port on the back of the Encore Controller. See Appendix A (Pin outs Section) of the Encore User Manual for information on how this port is physically wired.
PAGE 3
Encore Presentation System Router Support Rev 03  Barco MatrixPRO Analog, SDI and DVI routers o Pressing the "SAVE" button on the Controller will cause the current state of the router to be saved as Preset 1 in the router.
PAGE 4
Encore Presentation System Router Support Rev 03 device is connected to the Encore network, before applying Power to the Lantronix device. This will ensure that the Lantronix device will get a 192.168.0.xxx address from the Controller since the Controller is a DHCP server. If the Lantronix device does not see a DHCP server within 10 seconds, it will automatically assign itself a 169.xxx.xxx.xxx address which is not compatible with the Controller address scheme.
PAGE 5
Encore Presentation System Router Support  Rev 03 PureLink PM Series o Select the PureLink-2 protocol for the Manufacturer in the router setup menu. o Supports both Ethernet and RS-232 communications. o Router’s factory reset default IP is 192.168.0.2, which conflicts with SP2 Controller. Thus, set it to a unique IP or to the default IP suggested by the controller. Consult the PureLink users guide for help on setting up the router’s IP address. o IP port is fixed at 23.