Owner`s manual

PureLink by Dtrovision
19
The "OE" is an initiation command for Output Extender Scaler timing selection. The
characters and numbers that follow the "OE" command tell the system, set scaling
timing on selected Output. The last character “!” is found at the end of a command
code which tells the system to execute the command. For a complete list of command
characters and their functions, see examples below.
 OE command only applies to the HDMI with scaling Board and CAT5e/Fiber Output
Board with PM-CR102 (CAT5e) and PM-FR102 (Fiber) Extender Receiver.
T00 Auto T09 1080p (50Hz) T18 SXGA (1280x1024@75Hz)
T01 480p (60Hz) T10 1080p (59Hz) T19 SXGA (1280x1024@85Hz)
T02 576p (50Hz) T11 1080p (60Hz) T20 UXGA (1600x1200@60Hz)
T03 720p (50Hz) T12 SVGA (800x600@60Hz) T21 1360x768@60Hz
T04 720p (59Hz) T13 SVGA (800x600@75Hz) T22 1366x768@60Hz
T05 720p (60Hz) T14 XGA (1024x768@60Hz) T23 1440x900@60Hz
T06 1080i (50Hz) T15 XGA (1024x768@75Hz) T24 1920x1200@60Hz
T07 1080i (59Hz) T16 XGA (1024x768@85Hz)
T08 1080i (60Hz) T17 SXGA (1280x1024@60Hz)
Example:
Command Codes Action
*255OEO01T00!  Set Output 1 Extender Scaler timing to Auto
*255OEO02T11! Set Output 2 Extender Scaler timing to 1080p
PM CAT5e Receiver Compatibility Chart
Receivers
Compatibility
PM-CR101 PM-CR102 PM-CR103
PM Extender Compatibility
PM-CT101
PM-CT102
PM-CT103
PM-CT101
PM-CT102
PM-CT103
PM-CT101
PM-CT102
PM-CT103
RF6 Compatibility
PM-CT101-RF6
PM-CT102-RF6
PM-CT103-RF6
PM-CT101-RF6
PM-CT102-RF6
PM-CT103-RF6
PM-CT101-RF6
PM-CT102-RF6
PM-CT103-RF6
PM Matrix Board
Compatibility
PM-COS4 PM-COS4 PM-COS4