Owner`s manual

PureLink by Dtrovision

IR Cable Termination

PM series CAT5e (HDBaseT) standalone type extenders supports both 5V and 12V and it

can be selected by IR voltage switch on the side of the unit. Please choose the voltage that

IR cable requires. (Factory default is 5V)

* Please note that wall plate type extenders do not support IR signal transmission.

* Please note that IR transmission only works between standalone type transmitters and

extenders. IR transmission do not work with wall plate type extenders and PM matrix

router.

Please refer below for the IR cable termination;

Connector Pin Assignment

DC Input

Part Number Pin No. Description Remark

ECH350R-03

1 VCC( DC12V)

2 GND

3 GND

RS232/422

Part Number Pin No. Description Remark

ECH350R-03

1 TXD

2 RXD

3 GND