Owner`s manual

PureLink by Dtrovision
19
timing on selected Output. The last character “!” is found at the end of a command
code which tells the system to execute the command. For a complete list of command
characters and their functions, see examples below.
 OE command only applies to the HDMI with scaling Board and CAT5e/Fiber Output
Board with PM-CR102 (CAT5e) and PM-FR102 (Fiber) Extender Receiver.
T00 Auto T09 1080p (50Hz) T18 SXGA (1280x1024@75Hz)
T01 480p (60Hz) T10 1080p (59Hz) T19 SXGA (1280x1024@85Hz)
T02 576p (50Hz) T11 1080p (60Hz) T20 UXGA (1600x1200@60Hz)
T03 720p (50Hz) T12 SVGA (800x600@60Hz) T21 1360x768@60Hz
T04 720p (59Hz) T13 SVGA (800x600@75Hz) T22 1366x768@60Hz
T05 720p (60Hz) T14 XGA (1024x768@60Hz) T23 1440x900@60Hz
T06 1080i (50Hz) T15 XGA (1024x768@75Hz) T24 1920x1200@60Hz
T07 1080i (59Hz) T16 XGA (1024x768@85Hz)
T08 1080i (60Hz) T17 SXGA (1280x1024@60Hz)
Example:
Command Codes Action
*255OEO01T00!  Set Output 1 Extender Scaler timing to Auto
*255OEO02T11! Set Output 2 Extender Scaler timing to 1080p
PM Fiber Optic Receiver Compatibility Chart
Receivers
Compatibility
PM-FR101 PM-FR102 PM-FR103
PM Extender Compatibility
PM-FT101
PM-FT102
PM-FT103
PM-FT101
PM-FT102
PM-FT103
PM-FT101
PM-FT102
PM-FT103
RF6 Compatibility
PM-FT101-RF6
PM-FT102-RF6
PM-FT101-RF6
PM-FT102-RF6
PM-FT101-RF6
PM-FT102-RF6
PM Matrix Board
Compatibility
PM-FOS4 PM-FOS4 PM-FOS4