Owner`s manual

PureLink by Dtrovision

Emulation

The user can easily save an EDID data from any display devices directly onto the PM series

Transmitter. By saving display device's EDID information on the Transmitter, it will act as a

display to the Video source.

* Connect display device to PM series Transmitter's HDMI/DVI port and then press EDID

S/W button. It will copy and save display’s EDID information to Transmitter’s EEPRom.

Note) There may be display devices that are not allowing other device to

emulate its EDID data.

Note) Certain EDID data may not be compatible with some devices, in this case,

it is recommended to user scaling option receivers.

3.1 Cable Termination

• RS-232/422 cable

RS-232/422 Cable Termination

5-pin Phoenix connector is used for RS-232/422 communication between PM extender

Tx/Rx to the devices that are attached.

* Pinout from the left

Pin RS-232 RS-422

1 Tx Tx +

2 Not used Tx -

3 Ground Ground

4 Rx Rx +

5 Not used Rx -