User manual

-04-
3. INSTALLATION
3.1 PureLink WHD100-V2 Transmitter (TX) connections
3.3 Connect IR Extender / Sensor
3.2 PureLink WHD100-V2 Receiver (RX) connections
1.Connectmax.2HDdevices(HDMIOUT)viaHDMItoyourWHD100-V2Transmitter(HDMIIN).
2.ConnectyourHDTVorHDProjector(HDMIIN)viaHDMItotheWHD100-V2Transmitter(HDMIOUT)
 inordertousetheinbuiltloop-throughfunction.
3.ConnectthepoweradaptertotheDCINoftheWHD100-V2Transmitterandtoasocket.
PlugtheIRLEDExtendercableintotheIROUTconnectoroftheWHD100-V2Transmitter.Attachthe
IRLEDstothefrontofyourHDdevices.ThiswillnowsendallreceivedinfraredcommandsviatheIR
SensoroftheWHD100-V2Receiver.
NOTE: The IR Sensor Extender cable supports 36kHz to 56kHz (NEC, RC5, RC6) infrared remote
controls. Some devices may not be supported.
4. USAGE
4.1 Using the WHD100-V2
1.InserttwoAAAbatteriesintotheremotecontrol.
2.Oncethepoweradapterhasbeeninsertedintothesocket,thePureLinkWHD100-V2Transmitter
 andReceiverwillswitchonautomatically.
1.ConnectyourHDTV orHDProjector(HDMIIN) via anHDMIcable totheWHD100-V2 Receiver
 (HDMIOUT).
2.ConnectthepoweradaptertotheDCINoftheWHD100-V2Receiverandtoanelectricalsocket.
Note: Use the 2 plugs and 2 screws if you wish to attach the WHD100-V2 Receiver to the wall
(e.g. behind your HDTV).
1.If the WHD100-V2 is in Standby mode (red POWER LED), press the ON/OFF button of the
 WHD100-V2TransmitterandReceivertoswitchthemon.Ittakesabout80secondsforthesystem
 tostartup.
2.While warming up, the Power LED will ash blue until the signal connection between the
 transmitterandreceiverhasbeenestablished.
NOTE: Place the transmitter and receiver at least 2 meters apart to ensure a good connection.
-05-
ENGLISH
HD Media Player
Blu-Ray Player
DC IN
HD Projector HDTV
HDMI
IR Led Extender cable
Blu-Ray Player
IR Sensor
HD Media Player