User manual

3.SwitchtheHDTVorHDProjectorON,aswellasyourconnectedsourcedevices.
4.PresstheSOURCEbuttonuntilyouseethevideofromyourdesiredsourcedevice.Thetimeittakes
 toswitchbetweensourcesmaybeabout15-20seconds.
5.Ifeverythingisworkingcorrectly,thePOWERLEDandSOURCELEDwilllightupblueconstantly
 (seetableifnot).
Mode Status description
Power LED
receiver
Status LED
receiver
Display on
HDTV / projector
Standby
Lowpowerconsumption,
allfunctionsareo.
Red O
Startingup
Systemissartingup,thistakes
about80seconds.
Flashesblue Flashes
Noconnection
Ifthesystemisnotabletomakea
connectionfor80secondsduring
start-up,itcontinuestosearchfor
availablechannels.
Flashesblue Flashes
Connected
Noinputsignalavailablefrom
chosensource.
Blue Flashes3xpersecond
Videoresolutionisnotsupported. Blue Flashes1xpersecond
Videoresolutionisrecognised
andconnectionbetweentransmit-
terandreceiverisstable.
Blue Blue
Audioandvideowillbe
reproducedonyourHDTV/
projector
Button Function description Operation
POWER
SwitchestheWHD100-V2
receiver/transmitterON/OFF
Pointtowardsthetransmitteror
receiverandpressthebuttonto
switchthesystemONorOFF.
INFO
Showsinformationonthescreen
regarding„Channel“,„Source“,„Re-
solution“and„SignalQuality“.
Pressoncetoshowthisinformation
ontheHDTVorProjector.
Pressagaintoremovethisdisplay.
IR ChangesIRfrequency.
Pressoncetoshowchosenfre-
quency.
Pressagaintochangeto38kHz,
47kHzor56kHz.
SOURCE
SwitchesbetweenHDMIinputand
input2.
Pressoncetoswitchtotheother
sourcedevice.
SOURCE
1 - 2
4.2 Using the Remote Control
4.3 LOOP-LINK FUNCTION
Activate/Deactivatetheloop-linkfunctionoftheWHD100-V2Transmitter.
Activate:
IftheWHD100-V2TransmitterandReceiverarebothswitchedon,pressthereceiver‘spowerbutton
once.ThereceiverwillswitchtoStandbymodeandtheTransmitterwillswitchtoloop-linkfunction.
TheHDTVorprojectorconnectedtothereceiverwillthenshowaloop-linksymbolfor3seconds.
Deactivate:
Ifthe WHD100-V2 Transmitterand Receiverareboth switchedon, press the transmitter‘sPower
buttononce.ThetransmitterandreceiverwillswitchtoStandbymodeandtheloop-linkfunction
ofthetransmitterwillswitcho.TheHDTVorprojectorconnectedtothereceiverwillthenshowa
loop-linksymbolfor3seconds.
5. FREQUENTLY ASKED QUESTIONS
No connection
IfthePureLinkWHD100-V2isnotabletomakeastableconnectionfor80secondsduringstartup,
the PureLink WHD100-V2 Receiver is probably outside the range of the PureLink WHD100-V2
Transmitter. Place them closer to each other (a minimum distance of 2 meters apart) and check
whethertheconnectioncanbemade.
-06-
-07-
ENGLISH