User manual

-04- ENGLISH
3. INSTALLATION
3.1 The PureLink WHD030-V2 Transmitter (TX)
3.2 The PureLink WHD030-V2 Receiver (RX)
1.ConnectyourWHD030-V2transmittertoyourHDdevice(HDMIOUT)orlaptop(HDMIOUT).
2.Connect the power adapter to the USB port on the WHD030-V2 transmitter and to a socket.
 If your HD device or Laptop has a USB port you can also use the USB cable to power the
 WHD030-V2transmitter.
1.ConnectyourHDTV orHD Projector(HDMI IN) viaan HDMI cableto the WHD030-V2Receiver
 (HDMIOUT).
2.Connect the power adapter to the USB IN on the WHD030-V2 Receiver and to an electrical
 socket.
Note: Use the 2 plugs and 2 screws if you wish to attach the WHD030-V2 Receiver to the wall
(e.g. behind your HDTV).
4. USAGE
4.1 Switch the PureLink WHD030-V2 ON
1.Once both power adapters have been inserted into the socket, the PureLink WHD030-V2
 transmitterandreceiverwillswitchonautomatically.
2.While warming up, both power LEDs will ash blue until the signal connection between the
 transmitter and receiver has been established. It takes about 80 seconds for the system
 tostartup.
3.Ifthereisagoodconnectionbetweenthetransmitterandreceiver,bothLEDswilllightupand
 remainblue.
Note: Place the transmitter and receiver at least 1 meter apart to ensure a good connection.
4.2 Switch your equipment ON
1.Switch the HDTV or HD Projector ON and select the HDMI input on this device to which
 youhaveconnectedthePureLinkWHD030-V2Receiver.
2.SwitchtheHDdeviceorLaptoptowhichthePureLinkWHD030-V2transmitterisconnectedON.
3.IfthereisagoodconnectionbetweenyourHDdeviceandtheHDTV(orHDProjector),bothLEDs
 onthereceiverwilllightupinblueconstantly(seetableintheeventofanothersituation).
4.3 Standby mode
IfthepowersupplytothePureLinkWHD030-V2Transmitterisinterrupted(poweradapterorUSB
powercable),thePureLinkWHD030-V2ReceiverwillswitchtoStandbymodeafter10minutes.If
thePureLinkWHD030-V2Transmitteristhenpowereduponceagain,thereceiverwillautomatically
detectthisandswitchbackON.
Mode Status description
Power LED
receiver
Status LED
receiver
Display on
HDTV / projector
Standby
Lowpowerconsumption,
allfunctionsareo.
Red O
Startingup
Systemissartingup,thistakes
about80seconds.
Flashes blue Flashes
Noconnection
Ifthesystemisnotabletomakea
connectionfor80secondsduring
start-up,itcontinuestosearchfor
availablechannels.
Flashes blue Flashes
Connected
Noinputsignalavailablefrom
chosensource.
Blue Flashes3xpersecond
Videoresolutionisnotsupported. Blue Flashes1xpersecond
Videoresolutionisrecognised
andconnectionbetweentransmit-
terandreceiverisstable.
Blue Blue
Audioandvideowillbe
reproducedonyourHDTV/
projector
-05-