HDMI Extender over Single Cat.X with RS-232, 2-way IR, Ethernet & PoE User’s Guide Model no. PT-E-HD50 Designed in Germany Made in Taiwan © 2010 PureLink GmbH. All rights reserved. www.purelink.
Table of Contents Section 1: Getting Started .................................................................................................. 3 1.1 Safety and Notice .................................................................................................. 3 1.2 Introduction .......................................................................................................... 3 1.3 Package Contents ...........................................................................................
Section 1: Getting Started 1.1 Safety and Notice Please read all of these instructions carefully before you use the device. Save this manual for future reference. The PT-E-HD50 HDMI Extender over Single Cat.X with RS-232,2-way IR, Ethernet & PoE has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the PT-E-HD50 should be used with care.
— Support POE(Power over Cable) which can power both units from TX or RX with power supply. — — — — — — — — — — HDCP & EDID Bypass CEC support Auto equalization Pure unaltered uncompressed 7.1ch digital HDMI over Cat.
REAR PANEL — PT-E-HD50, transmitting unit (TX) DIP Switch: PIN#1: Setup the RS-232 mode for serial communication channel. PIN#2: For Firmware Update RS-232: Connect to serial port device with a DSUB-9 male-male or male-female cable here RJ45: Plug in a Cat-5/5e/6 cable that needs to be linked to the transmitting unit PT-E-HD50-RX. LED: TX/RX link indicator FRONT PANEL — PT-E-HD50, receiving unit (RX) IR TX: Infrared 3.5mm socket for plugging in the extension cable of IR blaster IR RX: Infrared 3.
REAR PANEL — PT-E-HD50, receiving unit (RX) DIP Switch: PIN#1: Setup the RS-232 mode for serial communication channel. PIN#2: For Firmware Update RS-232: Connect to serial port device with a DSUB-9 male-male or male-female cable here RJ45: Plug in a Cat-5/5e/6 cable that needs to be linked to the transmitting unit PT-E-HD50-TX.
Section 2: Specifications Item Units Unit Description HDMI compliance HDCP compliance Video bandwidth Video support HDMI over UTP Audio support Equalization Input TMDS signal Input DDC signal ESD protection PCB stack-up IR pass-thru RS-232 support Ethernet support POE support Input Output In / Out HDMI source control HDMI connector Min DIN connector RJ-45 connector Rotary control switch 3.
Section 3: Notice 1. All HDMI over CAT5 transmission distances are measured using Belden 1583A CAT5e 125MHz UTP cable and ASTRODESIGN Video Signal Generator VG-859C & VG-870B. 2. Incorrect placement of IR Blaster and Receiver may result in the failure of the IR extenders. Please check carefully before plugging in the IR extender to the respective IR sockets. Warranty will not cover the damage. 3.