User`s guide

www.purelink.de
14
2. Step by step for connecting matrix and controller
Step1: Use RS-232 cable to connect the RS-232 port on matrix and controller
Step2: Open the software and then choose the correct com port
Step3: Click connection button “ ”
Step4: Make sure the connection status is on connected status “ ”
3. FW/SW Version Button
Click “ ” button to show version information
4. COM Port Selection
Click “ ” button to select COM Port
5. Connection Status
1) Connected Status:
2) Connecting Status:
3) Disconnected Status:
6. Connect/Disconnect Button
Click this button “ ” to change connection status
7. Power On/Off Button
Click this button to power on/off
“ ” Power on status(Blue): Click this button to power off device(Standby Mode)
“ ” Power off status(Red): Click this button to power on device