User Guide MPX Series High Capacity Filter Housings FEB2022 For correct operation & installation, it is essential to observe these instructions.
What's Inside What's Inside Introduction ................................................................................................................................. 2 Guidelines and Warnings ..................................................................................................... 3 Positioning Your Filter............................................................................................................ 3 Installation Procedure ......................................................
Introduction Guidelines and Warnings • System Max Pressure Rating : 900 kPa Note: Where line pressure exceeds 500 kPa, an approved pressure limiting device must be installed to comply with Australian & New Zealand Plumbing Standards. (Ref. AS/NZS 3500.1:2021, Clause 3.3.4). • Protect the housing from water hammer. • Use on cold water line only (with water up to 52°C). For installation over 52°C please enquire as to a suitable housing. Protect the housing from freezing.
Installation Guide Installation Procedure 1. Isolate water supply and relieve pressure by opening a downstream tap. 2. Cut pipe to suit length of required valve and housing installation. 3. Use approved brass, galv/poly plumbing fittings to suit existing pipework. The female threads on the housing will receive tapered male threads. Thread into housing head carefully as too much tape or overtightening may cause it to split. Warning: Use PTFE thread seal tape on all connections.
Maintenance Replacement Guide You can obtain replacements from your local Puretec dealer. To maintain performance, warranty and standards use genuine Puretec replacements.
Maintenance 8 Allow water to run for 2 minutes to flush the system. 9 Close down stream tap and check for leaks. Flush system for 10 minutes after any period of non-use more than 2 days. For a period of non-use of 2 weeks or more, it may be necessary to replace the cartridge.
Warranty Notes Puretec water care products are designed, manufactured and supported by Puretec Pty Ltd the name you can trust for viable and proven water solutions. The complete range of Puretec products are developed, refined, made to meet and exceed stringent specifications for the worldwide market. Important: Sales of products are subject to our Terms and Conditions which are available upon request. All specifications, information and photos are a guide only and are subject to change without notice.
