Use and Care Manual

Introduction Installation Maintenance Troubleshoot WarrantySafety
Step 3: Install the drinking water faucet
Installation
When installing an additional faucet, many times there are already pre-drilled
holes available. Many sinks have a soap dispenser or spray hose hole that
can be used for this purpose. If there is no pre-drilled hole, please consider
hiring a professional, since some kitchen countertop materials may require
specialized tools.
Place the pop-up rubber gasket and base on the counter over the hole and
place the stem of the drinking faucet through in the order shown in the
illustration. The stem of the drinking faucet should be accessible from under
the sink.
Place the silicon washer onto the threaded stem and secure under the
counter by placing the 3/4” mounting nut on threaded stem and tightening the
mounting nut until the faucet can’t move freely.
Locate puried water output line (white PE tube) and insert into the drinking
water faucet quick-connect tting and ensure that it is secure. Once secured,
slide the locking clip into place.
Certain faucet models may not be equipped with a quick-connect tting.
Do not connect the other end to the Purlette system at this time