Use and Care Manual

Introduction Installation Maintenance Troubleshoot WarrantySafety
Step 4: Install the drain saddle
Mount Drain Saddle
at Either Location.
Locking Clip
Select a location on the drain pipe that is at least 3” straight length of
pipe, preferrably on a horizontal plane (B), for drilling a 1/4” hole through
one side of the drain pipe.
Next, align and install the 1/4” drain saddle’s quick connect tting with
the drilled hole. Attach the drain saddle to the drain pipe and tighten the
two screws. Once the drain saddle is secured, push the waste water
drain line (yellow PE tube) through the quick-connect tting on the saddle
and insert the locking clip to secure the yellow PE tube in place.
Do not connect the other end to the Purlette system at this time
Align the holes of the drain saddle and drain pipe with a drill bit.
A
B
Installation