Use and Care Manual
Introduction Installation Maintenance Troubleshoot WarrantySafety
Step 5: Connect water lines to Purlette system
Remove the protective silicon cover from the back of
purier to reveal connection ports.
Remove
Inlet
Outlet
Drain
InletOutlet
Drain
Connect each PE tube (now with quick-connector) to
corresponding port. Read the label carefully before
inserting. If a mistake is made, simply remove the
locking clip and gently push the quick connector release
lock in, near where the tube is attached, with one nger
to release the lock and pull the PE tube out. Do not use
force.
Attach quick-connectors to all three water lines and
make sure to push in to the marked line until you feel it
stop. Slide the locking clip in to secure the water line.
Repeat this process for all three water lines (white,
yellow, and blue PE tubes).
Installation