Use and Care Manual

Introduction Installation Maintenance Troubleshoot WarrantySafety

Step 6: Turn on the cold water supply and check for leaks

Connection Diagram

Turn on the cold water supply and open the three-way

feed water ball valve. Check each connection point

for any leaks. If a leak is spotted, immediately turn

off the cold water supply stop valve and ensure all

ttings are properly installed and tightened. Turn on

the cold water stop valve and open the three-way feed

water ball valve once again and check for any leakage.

Proceed to the next step if there are no leaks.

Now it’s time to check the system to make sure that

there are no leaks!

Do not plug in the Purlette system at this time.

Open

Installation