Use and Care Manual

Introduction Installation Maintenance Troubleshoot WarrantySafety
Maintenance
Replacing lter when indicator light is blinking
When a lter needs
to be replaced, the
corresponding lter
indicator light will
start to blink.
Close the three-
way feed water ball
valve.
Unplug the power
supply.
Remove the dust lid. Lift quick release
arm.
Locate the lter
handle and gently
pull up the expired
lter.
Open the drinking
water faucet to
release pressure for
easy lter removal.
1. 2. 3. 4. 5. 6. 7.
Re-open the three-
way feed water ball
valve and check to
make sure there are
no water leaks.
Replug the power
supply.
To install a new
lter, rst make sure
the lter connectors
are aligned to the
ports.
Press the quick
release arm down
gently until you
hear a pop sound.
Remember to put
back dust lid.
Flush the new lter,
before use, for at
least 15 mins.
Wait approximately
80 seconds for the
Purlette system to
initialize.
Long press the lter
RESET button for 3
seconds until you
hear a beep.
80 sec
RESET
3 sec
8. 9. 10.
11. 12. 13. 14.