Use and Care Manual
Introduction Installation Maintenance Troubleshoot WarrantySafety
Maintenance
Replacing lter when indicator light is not blinking
When replacing the lter without being prompted to by the system, you have to manually reset the lter.
Follow steps 2-12 on the previous page to replace the lter. Then follow these next steps to manually reset the lter:
One of the lter lights
will start blinking
indicating that lter has
been selected.
Short press the RESET
button to switch
between the RO lter
and the HYBRID lter.
Long press the RESET
touch button for 3
seconds until you hear a
“D” sound.
Once the correct lter
has been selected, long
press the RESET button
for 3 seconds until you
hear a “D” sound.
Once you have
successfully reset the
lter, the indicator light
should remain lit (non-
blinking).
RO
HYBRID
RESET
NETWORK
RO
HYBRID
RESET
NETWORK
RO
HYBRID
RESET
NETWORK
RO
HYBRID
RESET
NETWORK
RESET
3 sec
RESET
3 sec
Remember to ush the
lter prior to use.
1. 2. 3. 4. 5. 6.