Use and Care Manual
Introduction Installation Maintenance Troubleshoot WarrantySafety
Troubleshoot
Issue Possible Cause
Recommended Action
System is leaking
System won’t shut off after 3
minutes of non-use
• Possible faulty Hybrid lter cartridge
• Failure of the electrical circuit board or
solenoid valve
• Replace the Hybrid lter.
• Drain the residual water from the base and then
reset the system leakage detector by locating and
disconnect the tap water input line (blue PE tube)
from the purier inlet port, then reinsert in the tap
water input line.
• If problem persist, cut off power and water to the
system and contact customer support.
• Cut off power and water to the system immediately
by shutting off the three-way feed water ball valve
and unplugging the power cord.
• Contact customer support.