Use and Care Manual

Introduction Installation Maintenance Troubleshoot WarrantySafety
Network Connection Short press the NETWORK and RESET touch button simultaneously. The network indicator
light will begin blinking, indicating that the system is searching for nearby WiFi, and upon successful connection, will
stay lit (non-blinking). If a network connection is not established, the network indicator light will continue to blink and
the Purlette system will attempt to establish a network connection for 10 minutes and then turn off.
Energy-Saving Mode After 3 hours of non-use the Purlette system will automatically switch to energy-saving
mode. All indicator lights will be off during energy saving mode. When the drinking water faucet is used, an operation
panel button is pushed, or the system enters auto-cleaning mode the Purlette system will exit energy saving mode
and indicator lights will illuminate automatically.
Power-on All indicator lights blink for 5 seconds when the Purlette
system is plugged in, signaling that the system is starting.
Operation Mode Filter indicator lights will stay lit (non-blinking) while
lters are functioning properly. When the service life of a lter expires, the
lter indicator light for the expiring lter will begin blinking. The unexpired
lter light will continue to stay lit (non-blinking) until that particular lter
need to be replaced.
Auto-Cleaning The two lter indicator lights will blink in alternating
sequences during auto-cleaning mode.
Operation Panel
RO Filter
Indicator Light
HYBRID Filter
Indicator Light
RESET
Touch-Button
Network
Indicator Light
NETWORK
Touch-Button
RO
HYBRID
RESET
NETWORK