User guide

5 How to learn your RF thermostat with

the RF receiver

First of all, switch the button mode of the

thermostat in OFF position .

To learn (*) the RF thermostat with the receiver

you must put the receiver in “RF init” mode

(Please refer to the receiver leaflet).

Once, on the thermostat switch the button mode

on “Automatic” position .

o The thermostat will send now the RF signal to the

receiver. Check on the receiver the good

configuration.

o If the RF learning is not made correctly, check the

installation (antenna connection, supply voltage...)

o If the RF learning between the thermostat and the

receiver is good, put your thermostat in the off

mode .

o On the receiver you can exit the “RF init” mode or

configure another thermostat. (Please refer to the

receiver leaflet for this)

Now you can check the RF distance, go to the

room which must be regulated. Put your

thermostat on the final position (On the wall

support or on the table support), then put the

thermostat on the Automatic mode (setting

temperature 30°C). Close the door and go to the

receiver to check if the new status of the

thermostat has received.