Owner`s manual

2270 CENTER CONSOLE
Note: The bilge pump will start automatically when there is sufficient water in the bilge to
activate the float switch. The float switch is protected by a circuit breaker located
near the battery selector switch and is always supplied current when the batteries are
connected.
Anchor-Nav Lights
The switch is a three-position switch. The middle position is “OFF.” Moving the switch in one
direction will activate the navigation lights. Moving the switch in the opposite direction activates
the anchor light.
Courtesy Lights
Activates the lights that illuminate the cockpit area.
Panel Lights
Activates the engine gauge and compass lights.
Windshield Wiper
Activates the windshield wiper if this option is installed on your boat. If no wiper is installed, this
switch is reserved for additional accessories.
12-Volt Receptacle
Provides electrical current for portable 12-volt equipment.
Accessory Switches
These switches are supplied to activate additional equipment that may have been installed by
Pursuit or your Pursuit dealer. If no accessories are activated by these switches, they remain wired
in the panel in reserve. They are protected by 15-amp breakers. Some accessories that may be
connected to the accessory switches are: The spreader lights, electronics and livewell.
Additional Switch Panels
Additional switch panels may be located in various locations in the cockpit and helm area of the
boat. Most of these panels are equipped with one switch and one circuit breaker. The following
is a description of additional panels that may be on your Pursuit and the accessories they control:
Livewell Switch
This switch activates the baitwell circulating pump that supplies water to the baitwell.
Washdown Pump
Activates the washdown pump pressure switch located on the pump. The pressure switch
automatically controls the water pump when the system is activated and properly primed. It is
protected by a circuit breaker in the panel and an automatically resetting breaker on the pump motor.
4-3