Owner`s manual

2670 Cuddy Console

Chapter 7:

DRAINAGE SYSTEMS

7.1 General

All water is drained by gravity to overboard thru-hull fittings located in the hull sides above the waterline.

Some of the drain thru-hull fittings are equipped with ball valves that are always open under normal operating

conditions. In the event of an emergency, the valves can be closed to prevent sea water from entering the

boat through the drainage system. It is important to check and operate the drain valves at least annually to

make sure they are in good condition and operating properly. You also should check the drain system

frequently to ensure it is free flowing and that the hoses on the thru-hull fittings are secure and not leaking.

Please review the drainage schematic to become familiar with the location of the thru-hull drain valves.

SITUATIONS REQUIRING ONE OR MORE DRAIN VALVES TO BE CLOSED CAN BE PO-

TENTIALLY DANGEROUS TO THE BOAT AND YOUR CREW. IF THIS OCCURS, DISTRIB-

UTE PERSONAL FLOTATION DEVICES TO THE CREW AND TAKE ALL NECESSARY

SAFETY PRECAUTIONS, INCLUDING NOTIFYING THE COAST GUARD, UNTIL THE PROB-

LEM IS FOUND AND CORRECTED.

7.2 Cockpit Drains

Your Pursuit has two scupper drains located in the rear of the cockpit. Water is channeled away from all hatches

by a gutter or drain rail system. The water then drains overboard through the scupper drain system.

The scuppers are equipped with ball valves that are always open under normal operating conditions. The

valves are accessed through hatches located in the stern. In the event of an emergency, the valves can be closed

to prevent seawater from entering the boat through the scupper drainage system. It is important to check and

operate the valves at least annually to make sure they are in good condition and operating properly. You also

should check the drain system frequently to ensure it is free flowing and that the hoses on the thru-hull fittings

are secure and not leaking.

7.3 T-Top Drains

There is a hole drilled in one of the leg bases to prevent water from being trapped within the leg and provide

a wire chase for accessories. A small hole is drilled in the tubing at the base of the other legs, which are not

drilled for a wire chase, that allows water to drain.