Owner`s manual

2670 Cuddy Console
59
Helm
The helm and engine controls are located on an opening helm station.
The helm station is hinged at the bottom and opens to provide access
to service the helm equipment.
To open the helm station, unscrew the knobs at the top of the helm.
A strap holds the helm in the open position and prevents it from
opening too far. Always make sure the helm station clamps are
properly secured when the helm is closed.
ALWAYS MAKE SURE THE HELM STATION
LATCHES ARE PROPERLY SECURED BEFORE OPERATING OR TRANSPORTING YOUR
BOAT. IF THE HELM STATION IS NOT PROPERLY SECURED, IT COULD OPEN UNEX-
PECTEDLY AND DAMAGE THE BOAT OR CAUSE LOSS OF CONTROL.
UNDER NO CIRCUMSTANCES SHOULD THE HELM BE OPENED WHEN THE ENGINE(S)
ARE RUNNING. IN SOME SITUATIONS IT IS POSSIBLE TO ACCIDENTALLY ENGAGE
THE ENGINE SHIFT INTO GEAR AND/OR ADVANCE THROTTLE CONTROLS AS THE
HELM IS OPENING. THIS COULD RESULT IN LOSS OF CONTROL, DAMAGE TO THE
BOAT, AND INJURY TO PASSENGERS.
Console Cooler
A molded insulated cooler is installed under the front seat of the console. The cooler drains overboard through
the cockpit drain system. The cooler should be cleaned thoroughly after each use.
Console Storage Compartment
There is a large storage compartment below the helm in the center console. It is accessed through a door on
the starboard side of the console. The AC and DC breaker panels, the optional stereo, and the electronics access
panel are on the rear of the compartment. An optional dive tank rack can also be mounted in this compartment.
There are three bilge access doors in the compartment. The head intake and macerator discharge valves are
behind the rear door. The port door provides access to the rigging. The battery charger and other rigging
can be accessed through the starboard door. The areas accessed through these doors are part of the bilge and
are not intended for storage.
T-Top (Optional)
The Pursuit T-top is made of welded anodized aluminum and is designed to accommodate radio antennas, radar
antennas and navigation lights. It is equipped with an overhead storage compartment for life jackets and other
soft, light items and a courtesy light activated by a switch in the helm. It could also be equipped with optional
top gun outriggers and/or rod holders.
The T-top is not designed to support the additional weight of items like an instrument locker or a life raft.
Radar and electronics antennas must be mounted near the center section of the T-top in the area above the legs.
Do not mount any antennas or equipment to the brow area forward of the front legs or to the rear of the top.
The T-top is not design to support the weight of accessories in these areas.
Helm