Owner`s manual
2670 Cuddy Console
61
Chapter 10:
INTERIOR EQUIPMENT
10.1 Cabin and V-Berth
The cabin and V-berth are accessed through a door hatch and bi-fold door. The door hatch is equipped with
gas hatch lifters that will automatically hold the hatch in the full open or closed position. The cabin door has
a special latch that can be locked when the door is closed. Another latch secures the door in the open position.
Make sure the cabin door is properly secured in the closed or open position before operating the boat.
A removable step is provided for your convenience. To install the step, insert it into the slot in the port cleat
and then push it down firmly into the notch in the starboard cleat, ensuring that it locks in place.
The battery and holding tank compartment is located behind a hatch at the rear of the cabin below the
companionway door. The V-berth is equipped with removable cushions and storage below the cushions.
There also is rod storage on each side of the V-berth.
Daylight and fresh air are provided to this area by an overhead opening hatch. Additional lighting is provided
by 12-volt lights on the forward bulkhead.
10.2 Marine Head System
This system is provided as standard equipment. The flush water is
supplied by a thru-hull fitting, located behind the starboard access
hatch in the center console storage compartment, and a raw water
line. Before using, open the inlet valve on the head and pump to wet
the inside of the bowl. After use, close the valve and pump to
discharge the waste to the holding tank or overboard.
Waste is pumped into the holding tank where it remains until it is
pumped out by a waste dumping station or the optional overboard
macerator discharge system.
Holding Tank and Macerator Discharge Pump
The holding tank is located in the battery storage compart-
ment at the rear of the V-berth. When the tank is full it must
either be pumped out by an approved waste dumping station
through the waste deck fitting or be pumped overboard with
the macerator discharge pump, when legal to do so.
To operate the macerator discharge pump, open the discharge
ball valve located behind the port access hatch in the center
console storage compartment. Then activate the macerator
switch, located on the DC panel below the helm, until the tank
is emptied. Turn the switch to “OFF” and close the discharge
ball valve when pumping is complete.
Marine Head
DC Panel and Macerator Switch