Owner`s manual

2670 Denali

4.4 12-Volt DC Panels

HELM BREAKER PANEL

The helm and cockpit switch functions are protected by a breaker panel located below the steering helm. The

breaker panel is equipped with "push to reset" breakers that are protected from the elements by rubber boots.

These breakers are all normally on and cannot be manually turned off. Should one of these breakers trip from

overload, push the breaker plunger inside the boot to reset.

The following are descriptions of the accessories controlled by the helm switches.

HELM SWITCH PANEL

Port/Stbd

The fuel gauge switch panel is located at the helm and allows one fuel gauge

to be sued for both fuel tanks. With the ignition switch on, move the switch

to port and the gauge will show the fuel level in the port fuel tank. Move the

switch to starboard and the gauge will show the fuel level in the starboard tank.

Windlass

This switch controls the optional windlass. It is protected by a circuit breaker

of the type and rating recommended by the windlass manufacturer. See the

Exterior Chapter for proper use of the windlass.

Spreader

Activates the spreader lights located on the optional radar arch or hardtop.

These lights provide additional lighting for the rear of the cockpit.

Depth Sounder

Provides 12-volt current to the depth sounder.

Aft Bilge

Activates the aft bilge pump which is installed in the aft bilge under the fish

box. Depressing the switch will activate the manual pump.

12-Volt Accessory

The switch operates the 12-volt accessory outlets.

Panel

Activates the instrument lighting.

Cockpit

Activates the lights that illuminate the cockpit area.

Hard Top Light

Depressing this switch activates the light mounted underneath the hardtop.

Helm Switch Panel

Helm Breaker Panel