Owner`s manual

2670 Denali

The cockpit table and pedestal are stored in a large drawer in the rear of the seat base. The table pedestal mounts

to a pedestal base located in the rear of the cockpit, on the fishbox hatch. The motion of the boat can damage

the table and pedestal when it is under way. They should be properly stored in the drawer before operating

the boat above idle speed.

The rear facing bench seat converts to a sun lounge. To convert the seat to a lounge, release the latch just below

the port corner of the rear seat cushion and slide the rear seat base out. To convert the lounge to a bench seat,

lift the center cushions slightly, and then push the seat base toward the front of the lounge until the seat backs

are in the upright position. The spring latch will automatically lock when the seat is in the full up position.

Helm

The helm and engine controls are located on an opening console. Molded-in electronics storage is located

forward and to port of the engine controls. Hatches in the cabin provide access for installing and servicing

the gauges and electronics.

The helm section of the console is hinged and opens to provide access to service the helm equipment. To

open the helm portion of the console, unscrew the knobs located in the forward corners of the helm. The

helm can be tilted aft to expose the underside of the helm. Always make sure the helm station knobs are

properly secured when the helm is closed.

ALWAYS MAKE SURE THE HELM STATION LATCHES ARE PROPERLY SECURED BE-

FORE OPERATING OR TRANSPORTING YOUR BOAT. IF THE HELM STATION IS NOT

PROPERLY SECURED, IT COULD OPEN UNEXPECTEDLY AND DAMAGE THE BOAT OR

CAUSE LOSS OF CONTROL.

UNDER NO CIRCUMSTANCES SHOULD THE HELM BE OPENED WHEN THE ENGINE(S)

ARE RUNNING. IN SOME SITUATIONS IT IS POSSIBLE TO ACCIDENTALLY ENGAGE

THE ENGINE SHIFT INTO GEAR AND/OR ADVANCE THROTTLE CONTROLS AS THE

HELM IS OPENING. THIS COULD RESULT IN LOSS OF CONTROL, DAMAGE TO THE

BOAT, AND INJURY TO PASSENGERS.

Stern Cockpit Equipment

he stern cockpit area is equipped with a sink, removable cutting board, bench seat, livewell and cooler. The

sink is plumbed to the freshwater system and drains overboard. Refer to the Freshwater System chapter for

additional information on the freshwater system. A hatch below the

sink provides access to the starboard stern bilge. The raw water

pump, livewell pump, fishbox macerator pump, and engine rigging

are among the equipment mounted in this area.

The livewell is supplied by a raw water circulating pump and drains

overboard. Refer to the Raw Water System chapter for additional

information on the livewell.

The stern bench seat is hinged and opens to allow access to the

livewell and removable cooler. A gas hatch lifter holds the seat in

the open position and prevents it from opening too far. The cooler

is drained overboard by gravity. Removing the cooler provides

access to the stern bilge, the stern bilge pumps and other equipment

installed there.

Stern Equipment