Owner`s manual

2670 Denali

The hard top is not designed to support the additional weight of items like an instrument locker or a life raft.

Radar and electronics antennas must be mounted to the top between the front and rear legs. Do not mount

any antennas or equipment to the brow area forward of the front legs. The hard top frame is not designed

to support the weight of accessories in this area and could be damaged. The starboard rear leg is the wire

chase for lights and antennas mounted to the top.

The warranty for the hard top will be void if the top is modified in any way or heavy accessories like life rafts,

or electronics lockers are mounted to the top. Additionally, if items like radar antennas spotlights and other

accessories are mounted in the wrong location, the warranty could be void. If you intend to add equipment

or make modifications to the hard top, you should contact Pursuit Customer Relations to make sure the

equipment you would like to add or the intended modification will not void the warranty on the top.

Hard Top Canvas

Cold weather can make the clear vinyl material on the curtains stiff and difficult to stretch to the snaps.

This can be particularly difficult with new canvas that has been stored off the boat. Laying the curtains

in the sun for 30 minutes during the heat of the day will make installing them much easier in cold

weather.

Aluminum Arch With Bimini And Side Curtains

The canvas for Pursuit boats is custom fit to each boat. The bimini top is designed with a relatively flat

profile and a snug fit. The canvas is fit to the boat at the factory and the bimini top must be installed

properly in order for the clear connector and side curtains to fit.

To install the Bimini top, attach the main legs to the hinges using the quick release pins and attach the rear

of the bimini canvas to the radar arch. Next, open the bimini and attach the front bows to the deck hinges

on the top of the windshield frame. Use your body weight on the front corner of the bimini to pull down

and stretch the fabric until the eye on the bow lines up with the hole in the deck hinge. Secure each eye

to the deck hinge with the quick release pins. The bimini canvas should be stretched tight when both sides

of the front bow are secured to the windshield frame.

Attach the clear connector to the zipper at the front of the top and snap it to the top of the windshield frame

beginning with the center snaps. If the bimini top is adjusted properly, the clear connector will have to

be stretched just enough to pull out the wrinkles and reach the snaps on the windshield. The front bow will

continue to bear the main load of the top.

Once the clear connector is completely installed, the side curtains can be put on. Attach the side curtains

to the zippers on the sides of the bimini and to the front connector. Snap the curtains to the windshield,

deck and outboard snaps on the arch beginning with the forward snaps on the windshield. If the bimini

is adjusted properly, the side curtains will have to be stretched slightly to pull out the wrinkles and reach

the snaps. The main load for the top should remain on the front bows and the arch.

If you have the optional drop curtain, attach it to the aft bimini top and to the inboard snaps on the arch.

Snap the drop curtain to the deck and cockpit.

The warranty for the arch will be void if it is modified in any way or heavy accessories like life rafts are

mounted to it. Additionally, if items like radar antennas spotlights and other accessories are mounted in

the wrong location, the warranty could be void. If you intend to add equipment or make modifications

to the arch, you should contact Pursuit Customer Relations to make sure the equipment you would like

to add or the intended modification will not void the warranty on the arch.