Owner`s manual

2670 Denali
65
Chapter 10:
INTERIOR EQUIPMENT
10.1 Cabin and V-Berth
The V-berth in the cabin is equipped with removable cushions and storage below the cushions. There is storage
in sea bags on the port side and a magazine rack and rod holders on the starboard side.
Daylight and fresh air are provided to this area by an overhead opening hatch. Additional lighting is provided
by 12-volt lights on the forward bulkhead. The lights and other cabin equipment are controlled by switches
in a panel located near the cabin door.
Access hatches to the equipment compartment, battery switches and electronics are located in the rear cabin
bulkhead.
10.2 Marine Head System
The marine toilet is located in a compartment aft of the V-berth. The flush
water is supplied by a thru-hull fitting located in the equipment compartment
bilge aft of the cabin and a raw water line. Before using, open the inlet valve
on the head and pump to wet the inside of the bowl. After use, pump to
discharge the waste to the holding tank, then close the inlet valve and pump
the bowl dry. The waste remains in the holding tank until it is pumped out
by a waste dumping station.
Holding Tank
The holding tank is located in the bilge. When the tank is full, it must be pumped out by an approved waste
dumping station through the “waste" deck fitting or the overboard macerator discharge system.
Monitor the waste level in the holding tank and have it pumped out before it is completely full. If the
holding tank is allowed to overfill, the waste will overflow into the tank vent and then overboard.
Holding Tank and Macerator Discharge Pump
When the holding tank is full it must either be pumped out by an approved waste dumping station through
the waste deck fitting or be pumped overboard with the macerator discharge pump, when legal to do so.
To operate the macerator discharge pump, open the ball valve at the overboard discharge thru- hull fitting
located in the equipment compartment aft of the cabin bulkhead. Then activate the macerator switch until
the tank is emptied. Release the switch and close the discharge ball valve when pumping is complete.
The macerator discharge pump can only be run dry for ten seconds. Allowing the macerator pump
to run after the holding tank is empty will cause damage to the pump.
Marine Head