Owner`s manual

2870 OFFSHORE
14-6
Hard Top
It is imperative that all drain holes in the legs are open and that the legs are completely free of water.
Remove the canvas and thoroughly clean and store in a safe, dry place. Remove all electronics.
Coat all wire connectors and bus bars in the helm compartment with a protecting oil.
ALWAYS MAKE SURE THE LEG DRAIN HOLES ARE CLEAR WHEN THE BOAT IS LAID
UP FOR THE WINTER. WATER TRAPPED INSIDE THE HARDTOP OR RADAR ARCH LEGS
COULD FREEZE AND CAUSE THE LEGS TO SPLIT.
Special Notes Prior To Winter Storage
If the boat will be in outside storage, properly support a storage cover and secure it over the boat.
It is best to have a frame built over the boat to support the canvas. It should be a few inches wider
than the boat so the canvas will clear the rails and allow passage of air. If this cover is fastened too
tightly there will be inadequate ventilation and this can lead to mildew, moisture accumulation, etc.
It is essential to fasten the canvas down securely so that the winds cannot remove it or cause chafing
of the hull superstructure. Do not store the boat in a damp storage enclosure. Excessive dampness
can cause electrical problems, corrosion, and excessive mildew.
Whenever possible, do not use the bimini top or convertible top canvas in place of the winter storage
cover. The life of these canvases may be significantly shortened if exposed to harsh weather
elements for long periods.
PLACING AN ELECTRIC OR FUEL BURNING HEATING UNIT IN THE BILGE AREA CAN
BE POTENTIALLY HAZARDOUS AND IS NOT RECOMMENDED.
Proper storage is very important to prevent serious damage to the boat. If the boat is to be stored
indoors, make sure the building has enough ventilation. It is very important that there is enough
ventilation both inside the boat and around the boat.
Note: If the boat is to be stored indoors or outdoors, open all drawers, clothes lockers,
cabinets, and doors a little. If possible, remove the upholstery, mattresses, clothing,
and rugs. Then hang a commercially available mildew protector in the cabin.
14.3 Recommissioning
DO NOT OPERATE THE BOAT UNLESS IT IS COMPLETELY ASSEMBLED. KEEP ALL
FASTENERS TIGHT. KEEP ADJUSTMENTS ACCORDING TO SPECIFICATIONS.