Owner`s manual

2870 OFFSHORE
Accessory Switches (3)
These switches are supplied to protect additional equipment that may or may not have been installed
by Pursuit or your Pursuit dealer. If no accessories are activated by these switches, they remain
wired in the panel in reserve. Some accessories that may be connected to the accessory switches
are: The hardtop lights, spreader lights, or electronics.
12-Volt Receptacle
Provides electrical current for portable 12-volt equipment.
Additional Accessory Switch Panels
Additional switch panels are located in various locations in the cockpit and helm area of the boat.
Most of these panels are equipped with one switch and one circuit breaker. The following is a
description of additional panels that may be on your Pursuit and the accessories they control:
Baitwell Switch
Located under the gunwale in the cockpit. This switch activates the baitwell circulating pump that
supplies water to the baitwell. The pump is protected by a circuit breaker in the panel and an
automatically resetting breaker on the pump motor.
Washdown Pump
This switch activates the raw water washdown pump. The pump is the pressure demand type and
is protected by a circuit breaker in the panel and an automatically resetting breaker on the pump
motor.
Note: Please refer to the Raw Water Chapter for more information on the baitwell and
washdown systems.
Trim Tab Switch
Located in the helm. This switch controls the trim tab planes located on the transom of the boat. It
is protected by an accessory breaker located in the 12-volt helm switch panel. Please refer to the
Helm Control Systems Chapter for detailed information on the operation of the trim tab controls.
Engine Trim and Tilt Switches
Located in the helm. These switches may be installed in the engine control handle or on the helm
console, depending on the engines installed in your boat. They control the trimming and tilting of
the engines. Please refer to the Helm Control Systems Chapter and the engine owner's manual for
information regarding the proper use of the tilt and trim switches.
Fuel Gauge Switch
The fuel gauge switch panel is located at the helm and allows one fuel gauge to be used for both
fuel tanks. With the ignition switch on, move the switch to port and the gauge will show the fuel
level in the port fuel tank. Move the switch to starboard and the gauge will show the fuel level in
the starboard tank.
4-4