Owner`s manual

2870 OFFSHORE
6.3 Livewell
Sea water is provided to the livewell by a 12-volt diaphragm pump. This pump is designed to carry
a constant flow of water to the livewell. The pump is activated by the baitwell switch in the 12-
volt panel or a separate switch in the cockpit. An overflow built into the livewell automatically
controls the water level in the livewell. Always turn the pump off at the switch panel when the
livewell is not in use.
To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure the
valve at the intake thru hull fitting is open and activate the baitwell switch. When the water level
reaches the overflow, it will begin to circulate.
To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the
bottom of the livewell. When the livewell has completely drained, use the washdown hose to flush
the livewell and drain of debris.
The livewell supply thru hull valve should be closed whenever the livewell is not in use. This will
prevent water from entering the livewell while the boat is cruising.
Note: Do not use the livewell as a dry storage area when it is not in use. Sea water could
accidently be delivered to the livewell from the thru hull fitting and damage
equipment stored there.
DO NOT RUN THE LIVEWELL PUMP DRY FOR EXTENDED PERIODS AS DAMAGE TO
THE PUMP WILL RESULT.
ALWAYS TURN THE LIVEWELL PUMP SWITCH TO THE “OFF” POSITION WHEN LEAV-
ING THE BOAT UNATTENDED.
6-3