Owner`s manual

3070 CENTER CONSOLE
Marine Toilet
The marine toilet must be properly winterized by following the manufacturer’s winterizing
instructions in the marine toilet owner’s manual. Drain the intake and discharge hoses
completely using low air pressure if necessary. The head holding tank and macerator discharge
pump must be pumped dry and one gallon of potable water antifreeze poured into the tank through
the deck waste pump out fitting. After the antifreeze has been added to the holding tank, open
the overboard discharge valve and activate the macerator pump until the antifreeze solution is
visible at the discharge thru hull.
Note: Make sure you follow the marine toilet manufacturer's winterizing instructions
exactly.
Bilge
Coat all metal components, wire busses, and connector plugs, in the bilge with a protecting oil.
It is also important to protect all strainers, seacocks and steering components. The bilge pumps
and bilge pump lines must be completely free of water and dried out when the boat is laid-up for
the winter in climates where freezing occurs. Compartments in the bilge that will not drain
completely should be pumped out and then sponged until completely free of water. Dry the hull
bilge and self-bailing cockpit troughs. Water freezing in these areas could cause damage.
T-Top
It is imperative that all drain holes in the legs are open and that the legs are completely free of
water. Remove the canvas and thoroughly clean and store in a safe, dry place. Remove all
electronics. Coat all wire connectors and bus bars in the helm compartment with a protecting oil.
Clean the aluminum frame with soap and water and dry thoroughly. Apply an aluminum metal
protector to the entire frame to reduce corrosion and pitting.
ALWAYS MAKE SURE THE LEG DRAIN HOLES ARE CLEAR WHEN THE BOAT
IS LAID UP FOR THE WINTER. WATER TRAPPED INSIDE THE HARDTOP,
TOWER OR RADAR ARCH LEGS COULD FREEZE AND CAUSE THE LEGS TO
SPLIT.
Tower (Dealer Option)
It is imperative that all drain holes in the tower and hardtop legs are open and completely free
of water. Tower basket drains should be checked and cleared of debris. Remove the tower sun
shade, if installed, the belly band or other upholstery and thoroughly clean and store in a safe,
dry place. Remove all electronics. Coat all wire connectors and bus bars in the helm
compartment with a protecting oil. Cover the tower basket with a tarp and secure it properly.
Clean the aluminum frame with soap and water and dry thoroughly. Apply an aluminum metal
protector to the entire frame to reduce corrosion and pitting.
14-5