Owner`s manual

3070 CENTER CONSOLE
Stereo (Optional)
Supplies 12-volt electrical current to the stereo.
Helm Main
Supples 12-volt electrical current to the breakers and switches in the helm switch panels.
Electronics Main
Reserved for electronics installations.
Head Macerator
Supplies electrical current to the switch, that controls the macerator overboard discharge pump
for the holding tank. This breaker should be in the “OFF” position except when pumping out the
holding tank.
Shower Pump
Supplies 12-volt electrical current directly to the cabin drain float switch which automatically
controls the head sink drain and shower sump pump. This is a "push to reset" breaker that is
normally on all the time unless tripped by an overload. Make sure this breaker is on before using
the cabin shower.
Additional Breakers and Switches
Windlass
The windlass breaker is located on the TABS unit. Push the button on the breaker in to activate
the windlass control switch and pull it out to return the breaker to “OFF” whenever the windlass
is not in use. Turning off this breaker when the windlass is not in use will reduce the possibility
of accidentally activating the windlass.
Forward Bilge
The forward bilge pump breaker is located on the TABS and provides protection for the
automatic float switch on the forward bilge pump. Another breaker in the helm provides circuit
protection for the manual switch.
Aft Bilge
The aft bilge pump breaker is located on the TABS and provides protection for the automatic float
switch on the aft bilge pump. Another breaker in the helm provides circuit protection for the
manual switch.
DC Power
The DC power breaker is located on the TABS and provides protection for all DC power to the
Cabin DC breaker panel.
4-7