Owner`s manual

3070 CENTER CONSOLE
9-3
9.2 Hull
Swim Platform
Your Pursuit is equipped with an integral swim platform and engine mounting system located
in the stern of the boat. There are two inspection deck plates in the transom engine well to provide
access to the stern bilge and engine mounting bolts. Always make sure these plates are secure
before operating your boat.
Boarding Ladder
The boarding ladder is mounted to the rear of the stern
rigging station when it is in the stored position. To use the
ladder, remove it from the storage clips and slide the studs
into the special bracket on the port side of the transom. The
ladder floats and must be secured in the boarding position by
turning the cam lock on the ladder so it catches the bottom
of the transom ladder bracket. The ladder must be removed
from the transom bracket and properly secured to the storage
clips before starting the engine(s).
MOVING PROPELLERS ARE DANGEROUS. THEY CAN CAUSE DEATH, LOSS OF
LIMBS, OR OTHER SEVERE INJURY. DO NOT USE THE SWIM PLATFORM OR
SWIM LADDER WHILE THE ENGINE(S) ARE RUNNING. STOP THE ENGINE(S) IF
DIVERS OR SWIMMERS ARE ATTEMPTING TO BOARD. ALWAYS REMOVE AND
PROPERLY STORE THE LADDER BEFORE STARTING THE ENGINE(S).
Trim Tabs
The trim tabs are recessed into the hull below the swim platform and the trim tab pump is located
behind the access hatch in starboard stern of the cockpit. The trim tabs are an important part of
the control systems. Please refer to the Helm Control Systems chapter for detailed information
on the trim tabs.
9.3 Cockpit
IN CERTAIN CONDITIONS, OPEN EXTERIOR DOORS AND HATCHES THAT ARE
NOT SECURED PROPERLY CAN SLAM CLOSED UNEXPECTEDLY AND CAUSE IN-
JURY TO PASSENGERS OR DAMAGE TO THE BOAT. MOST DOORS AND
HATCHES ARE EQUIPPED WITH SPECIAL FASTENERS, HATCH LIFTERS, OR
SNAPS AND/OR STRAPS, TO SECURE THEM IN THE OPEN POSITION. ALWAYS
MAKE SURE THAT THESE HATCHES AND DOORS ARE PROPERLY SECURED
WHENEVER THEY ARE IN THE OPEN POSITION.
Boarding Ladder