Owner`s manual

3070 CENTER CONSOLE
Snaps should be lubricated periodically with petroleum jelly or silicone grease. Zippers should
be lubricated with silicone spray or paraffin.
The T-top enclosure must be removed when transporting the boat. Canvas enclosures are not
designed to withstand the extreme wind pressure encountered while trailering and will be
damaged. Always remove and properly store the enclosure before trailering or having your boat
transported by truck.
13.3 Head Compartment Interior
The interior can be cleaned just like you would clean a home interior. To preserve the teak
woodwork, use teak oil. To maintain the carpeting, use a vacuum cleaner. Because air and
sunlight are very good cleansers, periodically put cushions, sleeping bags, etc. on deck, in the sun
and fresh air, to dry and air out. If cushions or equipment get wet with saltwater, remove and use
clean, fresh water to rinse off the salt crystals. Salt retains moisture and will cause damage. Dry
thoroughly and reinstall.
If you leave the boat for a long period of time, put all cushions on their sides, open all locker doors
and hang a commercially available mildew protector in the cabin.
ALWAYS READ THE LABEL CAREFULLY ON MILDEW PROTECTORS. REMOVE
THE PROTECTOR AND ALLOW THE CABIN TO VENTILATE COMPLETELY BE-
FORE USING THE CABIN.
13.4 Bilge
Periodically check the bilge pumps for proper operation and clean debris from the strainers and
float switches. Inspect all hoses, clamps and thru hulls for leaks and tightness on a regular basis.
To keep the bilge clean and fresh, it is recommended that you use a commercial bilge cleaner on
a regular basis. Follow the directions carefully. All exposed pumps and metal components in
the bilge should be sprayed periodically with a protector to reduce the corrosive effects of the
high humidity always present in these areas.
Periodically check the bilge pumps for proper operation and clean debris from the strainers and
float switches. Inspect all hoses, clamps and thru hulls for leaks and tightness on a regular basis
and operate all thru hull valves at least once a month to keep them operating properly.
13-6