Owner`s manual

3070 EXPRESS
Note: The fuel gauge switch will not have any effect on the fuel supply to the engines. The
fuel supply must be controlled by the valves located near the fuel withdrawal tubes
on the fuel tanks.
Fuel Fills
A fuel fill deck plate is located on each gunnel, and is marked
“GAS.” The fuel fill is opened by turning it counter clockwise with
a special key. After fueling, install the fuel cap and tighten with the
key. Be sure to use the proper type and grade fuel. Refer to the
engine owner’s manual for additional information.
Note: Do not overtighten the fuel cap. If the cap is overtightened, the O-ring seal could
be damaged allowing water to contaminate the fuel system.
DO NOT CONFUSE FUEL FILL DECK PLATES WITH THE WATER OR WASTE FILL
DECK PLATES. THESE PLATES ARE ALSO LABELED ACCORDINGLY. IF GASO-
LINE IS ACCIDENTALLY PUMPED INTO THE WATER OR WASTE TANK, DO NOT
ATTEMPT TO PUMP IT OUT YOURSELF. WATER AND WASTE PUMPS ARE NOT
DESIGNED TO PUMP FUEL AND A FIRE OR EXPLOSION COULD RESULT. CON-
TACT YOUR DEALER OR THE PURSUIT CUSTOMER RELATIONS DEPARTMENT
FOR ASSISTANCE IN HAVING THE FUEL PROFESSIONALLY REMOVED.
Fuel Vents
There are two fuel vent fittings for the gasoline fuel tanks, one on each side of the hull. While
the tank is being filled, the air displaced by the fuel escapes through the vent. After fueling,
replace the fill cap(s), and wash the areas around the fuel fill plates and below the fuel vent(s).
Residual fuel left on the deck and hull sides can be dangerous, and will yellow the fiberglass or
damage the striping.
3-2
Gas Fuel Fill