Owner`s manual

3100 OFFSHORE

The Washdown Pump Connector

The washdown pump hose connector is located in the cockpit and uses

a standard garden hose connection.

ALWAYS TURN THE RAW WATER PUMP SWITCH TO

THE “OFF” POSITION WHEN LEAVING THE BOAT

UNATTENDED.

DO NOT RUN THE HIGH PRESSURE PUMP DRY FOR EXTENDED PERIODS AS DAMAGE

TO THE PUMP WILL RESULT.

6.3 Livewell

Sea water is provided to the livewell by a 12-volt pump. This pump is designed to carry a constant flow of

water to the livewell. The pump is activated by the livewell switch located in the cockpit panel. An overflow

built into the livewell automatically controls the water level in the livewell. Always turn the pump off at the

switch panel when the livewell is not in use. The livewell pump is equipped with a sea strainer on the intake

side of the sump located in the engine compartment.

To fill the livewell, insert the plug into the drain fitting at the bottom of the livewell. Make sure the valve

at the intake thru-hull fitting is open and activate the livewell switch. When the water level reaches the

overflow, it will begin to circulate.

To drain the livewell, turn off the livewell pump and pull out the plug in the drain fitting at the bottom of

the livewell. When the livewell has completely drained, use the washdown hose to flush the livewell and drain

debris. The livewell supply thru-hull valve should be closed whenever the livewell is not in use. This will

prevent water from entering the livewell while the boat is cruising.

DO NOT USE THE LIVEWELL AS A DRY STORAGE AREA WHEN IT IS NOT IN USE. SEA WATER

COULD ACCIDENTALLY BE DELIVERED TO THE LIVEWELL FROM THE THRU-HULL FIT-

TING AND DAMAGE EQUIPMENT STORED THERE.

Washdown Hose

Connector