Owner`s manual

3100 OFFSHORE
75
Hard Top (Optional)
The optional hard top consists of a laminated fiberglass top mounted to a welded aluminum frame that is bolted
to the deck. It is designed to accommodate radio antennas, radar antennas and navigation lights. It could also
be equipped with optional outriggers and/or rod holders. Three storage compartments are located at the
forward edge of the hard top.
The hard top is not designed to support the additional weight of items like an instrument locker, life raft or
helm station. Radar and electronics antennas must be mounted to the top between the front and rear legs. Do
not mount any antennas or equipment to the brow area forward of the front legs. The hard top frame is not
designed to support the weight of accessories in this area and could be damaged. The starboard legs provide
wire chases for lights and antennas mounted to the top. Because the aluminum frames vary slightly, the side
curtains, front clear connector and drop curtain are custom made to each boat at the factory.
The warranty for the hard top or arch will be void if they are modified in any way or heavy accessories like
life rafts or electronics lockers are mounted to the top. Additionally, if items like radar antennas spotlights
and other accessories are mounted in the wrong location, the warranty could be void. If you intend to add
equipment or make modifications to the hard top or arch, you should contact Pursuit Customer Relations to
make sure the equipment you would like to add or the intended modification will not void the warranty on
the top.
Hardtop Canvas
Cold weather can make the clear vinyl material on the curtains stiff and difficult to stretch to the snaps.
This can be particularly difficult with new canvas that has been stored off the boat. Laying the curtains
in the sun for 30 minutes during the heat of the day will make installing them much easier in cold
weather.
Aluminum Arch with Bimini Top and Side Curtains
The canvas for Pursuit boats is custom fit to each boat. The bimini top is designed with a relatively flat profile
and a snug fit. The canvas is fit to the boat at the factory and the bimini top must be installed properly for
the clear connector and side curtains to fit.