Owner`s manual

C 230
36
Washdown Pump
Pressing this switch activates the raw water washdown pump. The pump is the pressure demand type and is
protected by a circuit breaker and an automatically resetting breaker on the pump.
Note: Please refer to the Plumbing Systems chapter for more information on the livewell and washdown
systems.
ACC
This is open and held for future accessories not to exceed 10 amps.
4.4 Electrical System Maintenance
12-VOLT DC ELECTRICAL SYSTEM MAINTENANCE
At least once a year, spray all exposed electrical components behind the helm and in the plugs with a protector.
Exterior light fixture bulbs should be removed and the metal contact areas coated with a non-water soluble
lubricant like petroleum jelly or silicone grease. The sockets should be sprayed with a protector. Care must
be taken not to get any oil or petroleum jelly on the glass portion of the bulbs as this will cause the bulb to
overheat and burn out.
WHEN REPLACING LIGHT BULBS IN MARINE LIGHT FIXTURES, ALWAYS USE A BULB WITH
THE SAME RATING AS THE ORIGINAL. USING A DIFFERENT BULB COULD CAUSE THE
FIXTURE TO OVERHEAT AND MELT OR SHORT CIRCUIT.
Check all below deck wiring to be sure it is properly supported, that the insulation is sound, and that there are
no loose or corroded terminals. Corroded terminals should be thoroughly cleaned with sandpaper, or
replaced, tightened securely and sprayed with a metal and electrical protector. Inspect all engine wiring.
Check the electrolyte level in the batteries regularly and add distilled water as necessary. If the batteries are
frequently charged by a battery charger, the electrolyte level will have to be checked more often. The correct
fluid level in the cells is usually approximately 1/4 to 1/2 inch above the plates. If fluid is needed, fill to the
proper level with distilled water.
Do not over fill!
Please note that some batteries are sealed and cannot be filled. Keep the battery tops clean and dry. Dirt and
water can conduct electricity from one post to the other causing the battery to discharge.
The battery posts should be kept free of corrosion.
Wing nut connections should not be used to attach battery
cables. Remove the cables and clean the posts and cable clamps with a battery post cleaner or sandpaper as
required. Coating the battery posts and cable clamps with petroleum jelly or silicone grease will protect them
and reduce corrosion. Battery cables, both positive and ground, must be replaced when they show signs of
corrosion or fraying. Deteriorated cables cause a considerable voltage loss when high currents are drawn,
as for starting the engine.