Owner`s manual

4-2
Section 4 Electrical System
C 260
Electronics Main
These are reserved for electronic accesso-
ries installation. An electronic bus is located
behind the helm.
Helm Main
Supplies the 12-volt current to helm panel.
Windlass (Optional)
The windlass breaker is located on the MDP.
Push the red button to open the circuit
breaker. To reset or turn the circuit breaker
on, rotate the black lever to "ON." Turn off
this breaker when the windlass is not in use
to reduce the possibility of accidentally acti-
vating the windlass.
Other Breakers
All remaining devices and circuits are pro-
tected by '' ‘PUSH to reset’ breakers that are
normally in the ON position. If a breaker
trips, reset by pressing the plunger. Each
breaker is labeled with the name of the
device it protects.
The stereo memory and aft bilge pump float
switch are always ON. Bilge pumps and
bilge pumping systems are not designed for
damage control. Make sure all bilge pumps
are functioning at regular intervals. Debris
can also prevent the pumps from functioning
or operate continuously. Make sure no
debris is blocking the bilge pump float(s).
Continuous operation of the bilge pumps
can mean a leak or a drain plug is installed
incorrectly, make sure all drain plugs are
installed.
Power to the stereo is supplied by the stereo
breaker located on the helm panel. The for-
ward and aft sump breakers are not used.
Breakers also protect the engine charging
isolator wiring when used, the electric head
and the holding tank macerator. If you expe-
rience a battery-charging problem, check the
engine isolator breakers and reset as neces-
sary.
Downrigger circuits, are protected by a 30
Amp. breaker. For aftermarket installation,
wiring is provided and routed to the port and
starboard gunwales, just aft of the gunwale
boards. The proper and correct terminals,
must be provided by the installer for the
equipment selected for installation.
12V Main Distribution Panel