Owner`s manual

4-4
Section 4 Electrical System
C 260
Deploy Retrieve
Pressing the rocker switch deploys and
retrieves the anchor using the optional wind-
lass. Refer to the Windlass in the Exterior
Equipment.
ACC
This is open and reserved for additional
accessories. DO NOT exceed 10 amps.
Underwater Lights (Optional)
Activates the underwater lights. Use these
lights only when the boat is in the water as
they rely on water for cooling. The switch
will use one of the ACC switches.
12-Volt Receptacle
Power is provided to the 12-volt accessory
receptacle by a breaker located on the helm
panel.
Head Compartment Switch Panel
These switches are protected by breakers
on the MDP.
Electric Head (Optional)
Operates the electric head. Refer to the
head owner's manual for operating instruc-
tions.
Head Macerator
Press to activate the macerator for the hold-
ing tank, overboard discharge system. Refer
to the Interior Equipment Section of this
manual for additional information. This
breaker should be in the "OFF" position
except when pumping out the holding tank.
4.4 Electrical System
Maintenance
12-Volt DC Electrical System
Maintenance
At least semi-annually, spray all exposed
electrical components behind the helm and
in the plugs with a protector. Exterior light
fixture bulbs should be removed and the
metal contact areas coated with a non-water
soluble lubricant like petroleum jelly or sili-
cone grease. The sockets should be
sprayed with a protector. Care must be
taken not to get any oil or petroleum jelly on
the glass portion of the bulbs as this will
cause the bulb to overheat and burn out.
Check all below deck wiring to be sure it is
properly supported, that the insulation is
sound, and that there are no loose or cor-
roded terminals. Corroded terminals should
be thoroughly cleaned with sandpaper, or
replaced, tightened securely and sprayed
with a metal and electrical protector. Inspect
all engine wiring.
Check the electrolyte level in the batteries
regularly and add distilled water as neces-
sary. If the batteries are frequently charged
by a battery charger, the electrolyte level will
have to be checked more often. The correct
fluid level in the cells is usually approxi-
mately 1/4 to 1/2 inch above the plates. If
fluid is needed, fill to the proper level with
distilled water. Do not over fill!
Please note that some batteries are sealed
and cannot be filled. Keep the battery tops
clean and dry. Dirt and water can conduct
electricity from one post to the other causing
the battery to discharge.
! CAUTION
When replacing light bulbs in marine
light fixtures, always use a bulb with
the same rating as the original. Using
a different bulb could cause the fix-
ture to overheat and melt or short cir-
cuit.