Owner`s manual

4-6
Section 4 Electrical System
DC 325
Head Panel
Head Macerator Switch
The indicators on this panel display the hold-
ing tank level and also includes the holding
tank overboard discharge macerator switch.
The macerator switch can only be activated
when the key switch is fully turned. Refer to
Head Compartment of the Interior Equip-
ment.
4.4 AC System
Make sure the AC ground system is func-
tioning properly and a proper connection
exists between the shore power cord and
power inlet, the boat bonding system and
the outlet ground circuits. If there is any
doubt about the integrity of the ground cir-
cuit, disconnect the AC, contact a qualified
marine electrician and repair.
To reduce the risk of electrical shock, avoid
making contact with the shore cable or mak-
ing a connection to a live shore outlet, espe-
cially in wet conditions. DO NOT spray water
on electrical cables while washing down
decks.
The AC electrical system operates on a 120-
volt, 30 amp, 60 cycle system. Models with
CE designation; operate on a 230-volt, 16
amp, 50 cycle system.
The AC system is powered by the shore
power, the optional inverter or by the
optional generator. Your boat is equipped
with an isolation transformer. The isolation
transformer maintains correct AC polarity
regardless of the polarity of the shore power
supply and eliminates the need for a gal-
vanic isolation system. Refer to the isolation
transformer manual for additional informa-
tion.
All AC current is distributed to the AC com-
ponents through individual circuit breakers
located in the AC panel. The main breaker in
the panel protects the system from an over-
load.
4.5 AC Main Distribution
A.C. Distribution Panel
The AC panel is located in the port side
berth. The following are descriptions of the
! DANGER
ELECTROCUTION, FIRE OR
EXPLOSION HAZARD
Contact with live wires or working on
an energized electrical system can
cause electrocution. It can also cause
sparks, resulting in fire and/or explo-
sion. Both cases will result in death or
serious injury. DO NOT work on an
energized system or allow unqualified
personnel to work on the system.