Owner`s manual

Electrical System
4-3
Section 4
DC235 / DC265
Windlass (Optional DC265)
The windlass breaker is located on the MDP.
Push the red button to open the circuit
breaker. To reset or turn the circuit breaker
on, rotate the black lever to "ON." Turn off
this breaker when the windlass is not in use
to reduce the possibility of accidentally acti-
vating the windlass.
Other Breakers
All remaining devices and circuits are pro-
tected by '' ‘PUSH to reset’ breakers that are
normally in the ON position. If a breaker
trips, reset by pressing the plunger. Each
breaker is labeled with the name of the
device it protects.
The stereo memory and aft bilge pump float
switch are always ON.
Bilge pumps and bilge pumping systems are
not designed for damage control. Make sure
all bilge pumps are functioning at regular
intervals. Debris can also prevent the pumps
from functioning or operate continuously.
Make sure no debris is blocking the bilge
pump float(s).
Power to the stereo is supplied by the stereo
breaker located on the MDP or the helm
panel. The forward and aft sump breakers
are not used.
Breakers also protect the engine charging
isolator wiring and on the DC265 the electric
head and the holding tank macerator. If you
experience a battery-charging problem,
check the engine isolator breakers and reset
as necessary.
Downrigger circuits on the DC265, are pro-
tected by a 30 Amp breaker. For aftermarket
installation, wiring is provided and routed to
the port and starboard gunwales, just aft of
the gunwale boards. The proper and correct
terminals, must be provided by the installer
for the equipment selected for installation.
4.4 12-Volt DC Panel
Helm Panel DC235