Owner`s manual
35
C 280/S 280/C 310/S 310
Windlass (Optional)
Turn off the breaker when the windlass is not in use to reduce the possibility of accidentally activating the
windlass. To open the breaker turn the lever to the "OFF" position. To reset or turn on the circuit breaker,
rotate the lever to the "ON" position.
Other Breakers
The refrigerator (S 280 and S 310 only) is controlled by a toggle style breaker that can be turned on and off
at will.
All remaining devices and circuits are protected by 'push to reset' breakers that are in the normally "ON"
position. Should any of the breakers trip, the breaker can be reset by pressing the plunger. Each breaker is
labeled with the name of the device it protects.
The stereo memory and aft bilge pump float switch are always on regardless of the battery switch position.
Power to the stereo is supplied by the stereo breaker located on the helm panel. The forward and aft sump
breakers are not used.
Breakers are also provided to protect the battery charger wiring, engine charging isolator wiring, the electric
head and the holding tank macerator. Check the charger and engine isolator breakers and reset as necessary
if you experience a battery charging problem.
Downrigger circuits, protected by a 30 amp breaker, for aftermarket installation are provided with wiring that
is routed to the port and starboard gunwales just aft of the gunwale boards. Appropriate terminations for the
selected equipment must be provided by the installer.
4.3 12-Volt DC Panels
HELM PANEL
The helm panel contains switches and circuit breakers. The circuit breakers are 'push to reset' breakers that
are in the normally "ON" position. Should any of the breakers trip, the breaker can be reset by pressing the
plunger. The following are descriptions of the components controlled by the helm switches:
Overhead Lights
Activates the lights mounted underneath the hardtop. Pressing once is red; pressing again is bright white;
pressing the third time is dim white. If lights get out of sequence, depress the switch and hold for two seconds.
Cockpit
Activates the lights that illuminate the cockpit area.
Spreader
Activates the flood lights located on the hardtop.
Helm Panel