Owner`s manual

C 280/S 280/C 310/ S 310

PERIODICALLY INSPECT THE TRANSOM DOOR FITTINGS FOR WEAR, DAMAGE OR LOOSE

FIT. ANY PROBLEMS SHOULD BE INSPECTED AND CORRECTED IMMEDIATELY.

AFT SEATS

To open the aft seat, lift the bolster and carefully lower the cushion to the full lowered position. To close, lift

the bolster and carefully raise the cushion to the full closed position.

To open the aft facing seat, lift the bolster and carefully lower the cushion to the full lowered position. To

close, lift the bolster and carefully raise the cushion to the full closed position.

KEEP HANDS AWAY FROM THE SEAT MECHANISM WHEN OPENING AND CLOSING THE

SEAT.

BOW STORAGE COMPARTMENT

There are three storage compartments located in the bow. The port and starboard compartments, which are

lockable, are designed to store and secure three rods each and are equipped with straps to secure the rods

during boat operation. Always make sure the rods are properly secured in the storage rack before operating

the boat. The rod racks can be folded out of the way to provide more room for storage. The third compartment

is located in the cockpit sole and provides access to the water and holding tanks.

CASTING PLATFORM/SUN LOUNGE (Optional on the S 280)

The casting platform/sun lounge is hinged at the bow and locks onto the console cooler. Secure locks before

using the casting platform/sun lounge or before getting underway. The platform is equipped with gas springs

to support it in the "UP" position to allow access to the forward deck hatch. Secure all cushion snaps before

getting underway or before using the sun lounge.

TO PREVENT INJURY TO PERSONS, DO NOT ALLOW PASSENGERS TO STAND ON THE

CASTING PLATFORM/SUN LOUNGE WHEN THE BOAT IN UNDERWAY.

FORWARD TABLE AND SUNPAD FILLER (Optional on the S 310)

The forward table is provided with a protective cover and long and short supports. Secure the forward hatch

before using the table. The long support places the table at a comfortable seating height. The shorter support

places the table at the correct height to use the sunpad filler. To prevent damage to the table's finish whenever

the table is not in use, place the cover over the table. To complete the sunpad area, place the sunpad filler

cushion on top of the table. The table, sunpad filler and two supports are stored in the locker between the

forward seats.

TO PREVENT INJURY TO PERSONS OR DAMAGE TO THE TABLE, THE FORWARD HATCH

MUST BE SECURED IN THE FULLY LOCKED POSITION.