Installation Guide

16
Troubleshooting
TROUBLESHOOTING GUIDE
PROBLEM CAUSE CORRECTION
U.V. lamp will not light Check input voltage if below Install a voltage regulator
or above 120 volts
Line cord disconnected Check, replace
or outlet defective
Defective U.V. lamp Replace
Defective lamp ballast Check output voltage
Replace ballast
Loose open-circuit wire Trace out and repair
Leak at quartz nipple Defective or cracked O-Ring Replace O-Ring
O-Ring not seated properly Reposition O-Ring
Cracked Quartz Sleeve Replace Quartz Sleeve
Display not on Blown fuse Replace 3 amp fuse (fuse located at bottom of box)
Water damage Replace Box
Control Box LED Operation Status
• 30 Days remaining on UV Lamp Life – Flashing Yellow LED with an intermittent audible tone. Correction Replace UV Lamp
• End of UV Lamp Life- Flashing Red LED with an intermittent audible tone. Correction Replace UV Lamp
• UV Lamp Out- Continuous Red LED with a continuous audible tone. Correction Replace UV Lamp