Specifications

V97-600002 Page 6 of 31
2.2.1 Mounting the Inverter
1. Locate the wall studs in the desired location and align the mounting bracket
over the studs. Mark the mounting holes. Ensure that locations A and B (see
Figure 1) are aligned over the wall studs.
2. VERIFY THE BRACKET IS LEVEL. Ensure points A and B are aligned with
the wall studs. Drill 1/8” pilot holes for the screws.
• Use heavy-duty 1/4" x 2” coarse thread lag screws to secure points A
and B to the wall.
• Use an 1/8” screw to secure points C, D, E, and F (See Figure 1).
Figure 1: Mounting Bracket
3. Carefully hang the inverter on the upper part of the bracket. The hooks
located at the rear of the inverter should hang over the bracket.
4. Verify inverter is level.
5. Remove the front cover of the inverter by unscrewing the four cover screws
located around the front perimeter of the inverter.
6. Locate the inverter mounting hole below the power board. Insert the
mounting screw through the inverter and tighten securely.
F
E
D
C
A B
Mounting
hole