User manual

Ethernet cables must meet the T-568B wiring standard and must be less than

320 feet in length. If a longer cable is needed additional networking hardware

may be required.

Provide DHCP server access to the inverter and provide a path to the Internet

for https (port 443) from the inverter.

As shipped, the inverter requires DHCP to establish its IP address. Contact AE

Solar Energy Technical Support if a fixed IP address is required for your

network.

3. Locate the inverter's MAC address on the label on the communications

interface PCB.

When the Internet connection is established, go to the AE web site and navigate to

the PVP Commercial Monitoring page to register the inverter and begin using the

monitoring tools. Contact AE Solar Energy Technical Support if additional

information is needed on how to use the online tool.

To Verify Data Monitoring Connectivity

Verify connectivity using the following information:

1. Check the status light located on the front of the communication PCB in the

card cage on the right side of the upper compartment in the data monitoring

section.

If the green status light is in a solid on state, the data monitoring connection is

established. If the status light is not solid, troubleshoot the connection.

2. Register the inverter at the AE Solar Energy web site to complete the setup for

monitoring the inverter.