Unit installation

TURBOPOWER 99

WATER HEATER
PV500-12 07/13 23
NOTES:
1. ALL FIELD WIRING MUST BE IN ACCORDANCE WITH THE REQUIREMENTS OF THE LOCAL CODES AND THE NATIONAL ELECTRICAL CODE,
NFPA NO. 70, LATEST EDITION.
2. REMOVE JUMPER WHEN REMOTE PROVING INTERLOCK IS CONNECTED.
3. MOTOR WIRE FOR SINGLE PHASE, 1 1/2 HP MOTORS MUST BE 10 GA, ALL OTHER WIRING IS 16 GA. UNLESS OTHERWISE NOTED.
4. FIELD WIRE TERMINATIONS SHOULD BE EXTENDED TO THE BOTTOM OF THE CONTROL ENCLOSURE. PROVIDE 8” ADDITIONAL WIRE.
5. REMOVE JUMPER WHEN REMOTE ENABLE/DISABLE IS CONNECTED.
6. WHEN INSTALLED IN CANADA, ALL WIRING SHOULD BE DONE IN ACCORDANCE WITH THE CURRENT CANADIAN ELECTRICAL CODE.
7. USE ADDITIONAL GROUNDING LUGS WHEN NECESSARY.
8. WHEN ALOAF OPTION IS NEEDED, USE SAME RELAY (K2) BUT WIRE AS SHOWN IN OPTIONAL (ALOAF) WIRING.
9. THESE WIRES ARE NOT NEEDED WHEN THREE PHASE BURNER MOTOR POWER SUPPLY IS USED.
Wiring Diagram